PROCESS EQUIPMENT - SPRAY BALL
INSTALLATION
 
     
Our spray balls are optimally used in the low-pressure range, between 0.5 bar and 3.0 bar.
     
Recommended depth of the spray ball in a tank installation:
Type Pressure at spray ball in bar installation depth in mm
Type Pressure at spray ball in bar installation depth in mm
M 0.5-1.0 100
X 0,5 - 1,5 300
Y 0,5 - 1,5 300 - 400
A 0,5 - 2,0 500
B 1,0 - 2,5 500 - 700
F 1,0 - 2,5 500 - 700
C 1,0 - 2,5 500 - 700
D 1,5 - 3,0 600 - 800
     
Perigon / 360 degree spray pattern is required for heavily soiled containers and difficult to remove stains. This type of spraying ensures direct impact of the cleaning fluid flowing down the sides of the tank walls.
 
For low level soiling semi-angle spraying 180° upwards is sufficient. The lower portion of the tank is cleaned indirectly by cleaning fluid flowing down the sides of the walls.
 
If there are any fixtures inside the tank that require special attention, an additional installation of a semi-angle spraying device 180° downwards is recommended. This device can be installed alternatively either directly above or below the fixtures in question.
 
Choice of the appropriate type of spray ball depends on the following particulars:
    • distance of the ball from the tank walls
    • installation depth
    • tank dimensions
    • type of detergent
    • pump specifications
    • tank use
 
 
 
 
 
 
     
 
 
  1-800-554-1394  
 
  Registration | Login | Check Shipment | Trade Shows | Sitemap | Links   357 Spook Rock Road
Suffern, NY 10901
Tel: (845)368-3600
Fax: (845)368-3040
Contact Us